Over 200 articles can be obtained by going to the Plastics Technology website (www.ptonline.com) and searching by topic or my name for them.
Delta P Procedure
Open Loop or Closed Loop, Electric or Hydraulic, if you want your machine to provide velocity control and consistent fill times you must run with a Delta P, no exceptions.
Molders Success or ?
Some observations between molders that are surviving vs. those that are struggling.
Machine Evaluation
Is your injection molding machine functioning properly? For good processing or validation purposes, follow these experiments to get data on the state of your injection molding press. An "Oldie but a Goodie"
Using 100 Percent Regrind
Stop blending, you are contaminating the virgin. Check out the strategy of using 100 percent regrind. You can track it, test worst case issues, have better process control and never ruin good resin.
Safety in Injection Molding Plants
General discussion of safety tips, topics and concerns in injection molding plants.
Why & How to Do a Gate Seal Experiment
Not all parts should be run with the gate sealed. Learn why and how to tell if the part is better with or without gate seal.