Scientific Molding Articles

    Delta P Procedure

    Open Loop or Closed Loop, Electric or Hydraulic, if you want your machine to provide velocity control and consistent fill times you must run with a Delta P, no exceptions.

    Molders Success or ?

    Some observations between molders that are surviving vs. those that are struggling

    Machine Evaluation

    Is your injection molding machine functioning properly? For good processing or validation purposes, follow these experiments to get data on the state of your injection molding press. An "Oldie but a Goodie"

    Using 100 Percent Regrind

    Stop blending, you are contaminating the virgin. Check out the strategy of using 100 percent regrind. You can track it, test worst case issues, have better process control and never ruin good resin,

    Intensification Ratio, What is it & How to Calculate

    This article describes what intensification ratio is for hydraulic machines and demonstrates a method for calculating

    Safety in Injection Molding Plants

    General discussion of safety tips, topics and concerns in injection molding plants.

    Plastics Technology

    Why & How to Do a Gate Seal Experiment

    Not all parts should be run with the gate sealed. Learn why and how to tell if the part is better with or without gate seal.

    Plastics Technology